IKPEK 20pcs 2K3 Ohm Potentiometer Replacement for Dualsense PS5 Controller, Trim Pot Resistor Thumbstick Module Sensor for ALPS Analog Joystick

Not sure if one arrived broken or not. To minimize the repair work I just replaced the inner white piece. On the first attempt one of the clips was broken either by me or poor QC. Totally possible that I broke it while transferring to the controller so I can’t fault the product. Stick drift was heavy left on the left stick. After the replacement it is good as new. Time will tell how long this will last but as of now I’m saved from a replacement and can do it 18 more times 🙂 Also, the ribbon cables on these controllers are a thousand times better positioned and easier to connect in comparison to the ps4 controllers. If you are hesitant because you think all the tech packed into these will make it a harder job than it was on last gen this is not necessarily the case.

Purchased this to try and fix my PS5 controller unit as it had severe drift error on the left stick. I did not replace the entire potentiometer (soldering required, which I was lazy to do) but only the slider disc part inside each one of them. And it worked pretty well. Drift error gone. For now.

I have already replaced two of the resistors on two different controllers. I didn't have to solder anything. Just find the YouTube videos of how to do that. Also don't forget to calibrate it afterwards. Super easy, there are web sites that allow you to check drift before disassembly. And another web site to calibrate centre after assembly (it maybe a bit off, and you want it to be perfect)

its good it works with ps5 dualsense. replaced them and drift was gone. be sure to calibrate your dualsense befor you use it to play games

Die Potis sind nach langer Lieferzeit angekommen. Das beigefügte Werkzeugt erfüllt seinen Zweck, ist aber bei den meisten Hobbybastlern vorhanden.